Cosco High Back Booster Car Seat
From Dorel Juvenile Group

This high-back booster car seat, designed for children 22 to 80 lbs., features shoulder belt guides and a removable cup holder.

  • Amazon Sales Rank: #2143 in Baby Product
  • Brand: Cosco
  • Model: 22-209WAL
  • Dimensions: 16.40" h x 18.40" w x 30.00" l, 11.80 pounds

Product Reviews

Finding a suitable child restraint system when baby outgrows his infant car seat is much easier with the Cosco high back booster car seat. Although car seat laws vary from state to state, the general trend has been to raise age and weight minimums. Many states have already mandated that children should remain in a booster seat until age 8 and 80 pounds.


Cosco high back booster seat is a car seat that grows with your child.

One of the most economical car seats on the market from a trusted brand dedicated to safety and value, the high back booster seat provides comfort and protection for your most precious cargo.

For toddlers from 22 to 40 pounds and meeting the age requirement to upgrade from an infant seat, the forward-facing restraint system employs an internal five-point harness with a two-piece chest clip to keep your child secure. The seat is equipped with the LATCH (Lower Anchors and Tethers for Children) system for cars that are capable of using this feature, but it also allows parents to use the automobile seatbelts. It has two harness heights for a better fit, although this does require rethreading.

When the top harness guides are below the child's shoulders and the child weighs over 40 pounds, remove the harness and convert the seat into a belt-positioning booster. The two belt positioning guides will ensure a snug fit. The maximum weight for the belt-position booster seat is 80 pounds.

The booster seat is wide and roomy. The padded area around the head gives children space to doze in the back seat. The removable cup holder clips onto the side of the car seat and comes in handy for longer trips. It is reachable by the child, which is sometimes overlooked by other car seat makers. The padding is comfortable and is fully removable. The manufacturer recommends washing it in warm, sudsy water. The plaid isn't haute couture, but this car seat is more focused on safety and value, and it meets all expectations. --Scott Teal


Combination high back/belt positioning booster to secure your child from 22-80 pounds.


Good seat for toddlers4
This is a solid seat that will fit well in most compact cars.

I ended up sending this back due to the fact that while the product description says it is for 22lbs and up, the box adds a minimum height requirement (36 inches) that I did not see on Amazon. Quite possibly it's listed somewhere and I missed the line. Just something to be aware of.

Comfortable and easy to use5
The top clip is not difficult for me to use but my daughter hasn't figured it out yet - which is the way I want it. I've also used it as a booster and I was satisfied with the way the buckle looped through and stayed in place. I also like the strap on the bottom that allows me to add a little slack or tighten it a little. I think that's a really important feature - especially in this season when my kid may be wearing a jacket one day and none the next and also if you use the car seat for different kids that are similar but not exactly the same size. I have another car seat without that and I find that sometimes I can't get it closed because it's too tight and sometimes there's too much slack.

Try before you buy3
I hate to say it - but this is the seat that has officially turned me into a Britax snob. The only car seats I had experience with prior to trying this one were the Graco baby bucket and the Britax Roundabout and Marathon. I had heard now and then the frightening statistic that so-and-so percentage of car seats are installed incorrectly and I couldn't understand how that could be - how hard is it to install a car seat properly? Turns out, it depends on the car seat.

We were recently visiting family back east and my nephew has this particular car seat - one in my father's car, one in my brother's car. One on occasion I was going to go somewhere with my dad and rather than go in our car or move our car seat to his car, we opted to use my nephew's seat for my son. However, it turned out the straps were on the lowest setting which was too low for either of the boys so I took the car seat out to adjust the straps and... quickly came to regret not simply moving our own car seat to my dad's car.

This seat is a royal pain in the behind to install properly. In theory, it goes in just like a Britax - clip the two LATCH hooks on either side, clip the third hook at the top, put your weight in and pull all the straps tight. However, the way the lower strap went through this seat, I just could not get it tight to my satisfaction - the front would wiggle easily no matter what I did. And the top hook is just pure evil by design - it is very, very complicated to tighten.

I looked in the manual, I looked on line, I called a friend who I remembered had one of these seats as an "extra." The best I could figure out, this model is sold with two different types of top anchor strap. One has a normal seeming strap that you just pull to tighten... and you lift up on the tightening portion of the strap to loosen. The other has this insanely convoluted piece of metal with several slits in it for the strap to pass through and wrap back and forth and under and around itself. With the latter, you pretty much need to guess how long or short to make the strap BEFORE you install the seat, because adjusting it on the fly is difficult if not impossible.

I checked at Target the other day and the seat they are selling there had the "easier" style of top anchor tightener but I don't know if they are all like that now. The manual we had for the seat listed both types. Be sure when you buy that the top strap has the easier type of adjuster.

Beyond the top fastener issue, though, like I said, I found it hard to get the bottom strap just right. We had to have a complicated system of towels under the seat in my dad's car to help it sit in there solid - aside from the positioning aspect of things this seat has two raw plastic protrusions on the bottom which have begun to slice in the seat in my dad's car (Hyundai Sonata)

One one occasion we moved my nephew's car seat to our rental car (Saturn Aura) to take both boys somewhere and we had no better luck with ease of installation. It still took a lot of sweating, straining, and swearing to get it in there.

With our Britax seats, I have never had a problem in any vehicle with making the car seats fit, and I can have them removed and re-installed in less than 5 minutes. The Cosco seat drove me crazy. I will give this seat 3 stars because it is affordable and is supposed to meet safety requirements but I would not buy it without making very sure it fits in YOUR car and that is has the easier to use top strap attachment. I would also not suggest it if there is much chance of your having to move the seat frequently. And protect you seats with something if you don't want them getting torn up!

Leave a Reply

Pagelines
Converted by Wordpress To Blogger for WP Blogger Themes. Sponsored by iBlogtoBlog.
preload preload preload